1、When entering an expressway toll gate, the driver should select a gate where _______.
A、There are more vehicles
B、The red light is on
C、The green light is on
D、Service is temporarily suspended
Answer：C
2、The oil pressure of engine may be too high if it lights.
A、Right
B、Wrong
Answer：B
3、If a motorized vehicle causes a traffic accident on the road, the driver should immediately move the vehicle to the roadside.
A、Right
B、Wrong
Answer：B
4、This sign indicates jammed section ahead and passing slowly.
A、Right
B、Wrong
Answer：B
5、This sign indicates obstacle ahead and bypassing from left side.
A、Right
B、Wrong
Answer：A
6、When driving a vehicle through an inundated road with non-motorized vehicles on both sides, the driver should _________.
A、Reduce speed and go slowly
B、Go forward normally
C、Speed up and pass
D、Continuously honk
Answer：A
7、How to use lights when changing to the left lane on road?
A、turn on the right-turn signal in advance
B、not need to turn on any turn signal
C、turn on the left-turn signal in advance
D、turn on the low beam lights in advance
Answer：C
8、Whats the meaning of this sign?
A、lane direction indication
B、intersection ahead
C、lane information indication
D、road branching point ahead
Answer：B
9、Whats the meaning of the yellow broken line on curbstone?
A、no temporary stopping
B、no taking and dropping people
C、no loading and unloading cargos
D、no long stopping
Answer：D
10、Before a vehicle enters a curve of a mountain road, the driver ______ if there is no vehicle coming in the opposite direction.
A、Should reduce speed, honk and drive on the right side
B、Should drive along the outer side of the curve
C、May briefly borrow the opposite lane
D、May speed up and pass along the tangent line of the curve
Answer：A
11、The traffic lights allow the vehicle to ______
A、turn right
B、stop and wait
C、turn left
D、go straight
Answer：A
12、What marking is the white polylines in the circle?
A、ascertaining the distance between the vehicles
B、driving at reduced speed
C、ascertaining the speed of the vehicles
D、reducing the speed at the intersection
Answer：A
13、When following a vehicle, the following vehicle may use the high beam light.
A、Right
B、Wrong
Answer：B
14、Whats the meaning of this sign?
A、slippery section
B、sharp curve
C、test driving section
D、curve section
Answer：A
15、When a vehicle changes lane before an intersection, the driver should do so ______.
A、In the area marked by solid lines before the intersection
B、In the area marked by solid lines in the intersection
C、In the area marked by broken lines as indicated by the guide arrow
D、Before the stop line at the intersection
Answer：C
16、How the front vehicle to run in this situation?
A、run as normal
B、yield
C、turn on the hazard lights
D、should not change lane
Answer：B
17、Driving across the double solid lines is _______
A、rule-breaking act
B、violation of law
C、faulty act
D、violation of regulations
Answer：B
18、This sign indicates construction section ahead and bypassing from left or right side.
A、Right
B、Wrong
Answer：B
19、When a vehicles turns, it should do so on the right side and refrain from occupying the lane of the other party. The left turn should be gentle and the right turn should be sharp.
A、Right
B、Wrong
Answer：A
20、This sign reminds the lane or the road narrows on the right side ahead.
A、Right
B、Wrong
Answer：A